Antenna Tuner BALUN
Doublets or loops are often deployed on multiple frequency bands using an antenna tuner.
Often balanced transmission lines are chosen to feed such antennas, in order to ensure low losses, even under high VSWR conditions.
Two wire transmission lines however only act truly symmetrically when driven by a perfect balanced source.
Most antenna tuners however are a-symmetrical (unbalanced) with respect to ground.
Therefore a balanced to unbalanced network is needed to adapt both natures.
This function is perfectly accomplished by a good wideband common-mode choke type BALUN placed at the output of an a-symmetric antenna tuner.
As this BALUN is placed in a random impedance environment, it can be subjected to very high voltages or currents.
So the two wire transmission line on such BALUN needs to be designed for high voltage withstand, rather than for a 50 Ohms characteristic impedance.
To accomplish this the Teflon insulated wires are additionally slipped in Teflon sleeves having a voltage withstand of 48 kV/mm.
This ensures that it will not arc over, even when positioned in a voltage node, as a result of e.g. an antenna being half wave resonant at some frequencies.
This BALUN is a special variant of the standard 1/1 Common-Mode Choke current BALUN wound with a two wire transmission line instead of a Teflon coaxial cable.
It is available with a coaxial input connector, as well as with screw terminals an input and output.
It can be deployed at the output of an a-symmetrical antenna tuner, at the transition between coaxial cable and balanced line in a G5RV configuration or even after a symmetrical antenna tuner to maximize symmetry and block any common-mode current that may be caused due to the inevitable unbalance in any antenna.
Constructed to the high quality standards known in ON7FU Ferrite Application Products.
Max power: 1200 W PeP (ICAS)
Frequency range: 1,5 – 55 MHz (Depending on the version, see label on the product).
Mounting option included.
Water proofing: IP 68